![]() – Operate this opener with AC 120V/60Hz power supply ONLY.ĭO NOT REUSE PARTS FROM ANOTHER BRAND OF OPENER!!!īEFORE beginning Installation: 1. To prevent damage to the door and opener: – DISABLE ALL LOCKS and REMOVE ALL ROPES connected to the garage door BEFORE installing and/or operating the opener. – Always have a qualified garage door service technician make any required adjustments and/or repairs to your door before proceeding with installation. – A poorly balanced door can cause serious injury and damage to the opener. ![]() – Before beginning installation of the opener please complete the following test to ensure that your door is balanced and in good working condition. Lag Screw 5/16″ x 1-1/2″ - Header Bracket / Mounting Opener X 2 Self-Threading Screw 1/4″ x 5/8″ Door Bracket X 1 Clevis Pin - Header Bracket 5/16″ x 1-1/2″ INSTALLATION HARDWARE, LOCATED IN HARDWARE BAG (SHOWN IN ACTUAL SIZE) Photo Eye Safety System Rail - End Segment with Trolley Stop Bolt ![]() *See Accessories in Repair Parts section of this manual for purchase information. (If light bulb is not installed, `click’ represents the light) ![]() Courtesy light turns on/flashes with audible `click’. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |